A Brief Discussion on Some Important Technical Performances of PCB Ink

PCB ink is an important component in the fabrication process. Its performance depends on several characteristics, including its viscosity, plasticity, adhesion, hardness, and water and solvent resistance. It also has properties that help it resist temperature and acid and alkali. Besides, it’s soluble, which helps it act as a bonding material.

Viscosity

Viscosity of PCB ink is an important factor in screen printing, one of the most important PCB manufacturing processes. The ink must have a high viscosity and good thixotropy to ensure accurate image reproduction. Viscosity is the internal friction that a liquid faces when being agitated or stirred. Thicker liquids have greater resistance while thinner liquids have less. The viscosity of PCB ink is measured in poises. It can vary considerably based on temperature.

The ink viscosity of PCB circuit boards depends on the type of PCB board and printing process. A high viscosity can cause leakage and damage to graphics edges. To avoid these issues, it is important to reduce the viscosity of the PCB ink. This is achieved through the use of a diluent.

Plasticity

The plasticity of PCB inks can be a big problem for screen printers, but it can be addressed through diluents. Using diluents will decrease the viscosity of the PCB ink, giving the printer a higher resolution. Also, it will allow the printer to achieve higher resolution levels without the risk of smearing or other problems caused by inks with high viscosities.

PCB inks are used in screen printing and other printing processes. These inks have several properties, including high hiding power, high viscosity, and opacity. They are typically white, but they can also be colored, or have text, symbols, or other types of information printed on them. This way, they can highlight important information or warn of hazards.

Resin content

The first step in cleaning PCB ink is to remove any excess resin. To do this, you can use a piece of transparency film and gently press it against the PCB. Then, use a paper towel to blot off any excess resin. Make sure that you expose any copper pads or extra artwork, as they may have been covered by the resin.

Typically, the solder resist ink will contain a photosensitive epoxy resin. This type of resin contains a chalcone group-containing compound and a curing agent. Other ingredients in the PCB ink include an organic solvent and a filler. The resin content of PCB ink can cause reduced dielectric resistance and may cause shortcircuiting or blistering of the PCB.

Adhesion

The adhesion of pcb ink is an important aspect in the manufacturing process. The adhesion of PCB ink depends on its type and substrate. Some of the commonly used types are UV, thermal, and photosensitive. These types of inks are very good in adhesion to various types of substrates.

The carbon ink PCB has excellent adhesion and peeling resistance. Its resistance change rate is about 10%. Its resistance square is about 20 ohms, which makes it excellent in electronic component packaging. As a result, it is often used as an alternative to gold keys and other expensive metals.

Resistivity

Resistivity is a material property. There are many different types of resistance, including Electrical Resistivity, Specific Resistance, Bulk Resistivity, and Volume Resistivity. Some materials have higher resistivities than others, and some have lower resistivities than others. Resistivity can also depend on temperature. For example, copper can vary in resistivity, depending on its preparation and formulation.

In the fabrication of printed circuit boards, it is important to measure the resistivity of the ink. In general, resistance is measured as a ratio of initial impedance to cured resistance. This measurement provides a useful reference when optimizing the conductivity of printed devices.