Entries by [email protected]

Elektroniikan suunnittelu ja valmistajat Singaporessa

Electronic Design and Manufacturers in Singapore The electronics industry in Singapore is an incredibly active and growing one. In 2017, more than a quarter of the country’s GDP was attributed to the industry. With a thriving electronics industry, it is no surprise that Singapore is one of the leading electronics exporters. While the region is […]

Basic Rules of Layout and Components Wiring

Basic Rules of Layout and Components Wiring There are some basic rules that should be followed when designing a layout. These include keeping the power and ground planes within the board, avoiding cross-netting, and placing the most critical components first. You should also try to place ICs and large processors inside the board. By following […]

Why Active Components Are More Expensive Than Passive Components

Why Active Components Are More Expensive Than Passive Components Electronics are a central part of our modern world and are used in almost every industry. These devices depend on a variety of crucial components to function properly. However, active components are more expensive than passive ones. This article explores the difference between the two types […]

Miten tehdä ESD-suojaus SMT-kokoonpanon aikana?

How to Do ESD Protection During SMT Assembly Electrostatic damage is a major cause of device failure. It is responsible for causing direct failures in as much as 10% of electronic devices. It can cause problems throughout the SMT assembly process. Fortunately, there are ways to protect yourself from this problem. Static protective material It […]

Miten erotamme puolijohdediodin tasavirtaresistanssin ja dynaamisen resistanssin?

How Do We Distinguish the DC Resistance and Dynamic Resistance of a Semiconductor Diode? In order to understand how the resistance of a semiconductor diode varies with current and voltage, we need to distinguish the two different types of resistance. The two types of resistance are static and dynamic. Dynamic resistance is much more variable […]

3 Tips For PCB Drawing Beginners

3 Tips For PCB Drawing Beginners For beginners, it is important to follow a few basic principles when drawing PCBs. These include the use of multiple grids, keeping parts 50 meters apart, and using 45-degree angle traces. The ancients once said that ice is difficult to break, but you can break it with persistence and […]


Varoitus: sprintf(): Liian vähän argumentteja /www/wwwroot/pcba123.com/wp-content/themes/enfold/framework/php/function-set-avia-frontend.php verkossa 1326