Как подключить печатную плату

There are different methods for wiring a circuit board. There is the lap-soldered connection, the wrapped wire and soldered connection, and the Terminal block and jumper wire. Each one has its advantages and disadvantages. Before you begin, make sure you have the necessary tools and knowledge to do this project.

Lap-soldered connection

One common connection method used when wiring circuit boards is the lap-soldered connection. This method requires a fine-pitch solder joint and is recommended when the board will experience minimal movement. This type of connection is not suitable for all applications. For example, if a wire has bends, you may need to make an overlap solder joint connection. For this connection to be successful, you must make sure to overlap the existing circuit by at least two times the width of the new one.

Lap-soldered connections are best suited for low-complexity designs or applications that are not highly sensitive to environmental factors. To make a lap-soldered connection, clean surfaces, strip cable insulation, and solder the header pin to the bare conductor. The exposed conductors are then covered with heat shrink tubing.

To make a good solder joint, you must first heat the solder to the proper temperature. If the solder is too hot, it can cause the joint to break and cause damage to the components. Also, you must use a good-quality solder. You can buy it at a hardware store or an electronics supplier.

Wrapped wire and soldered connection

Wire wrapping is the fastest way to connect wires and components, but it requires a little bit of skill. Well-done wire wraps have contact resistance that is almost as low as that of a soldered connection, which is why it’s one of the most preferred wiring methods for electronic components. It’s also easy to modify. You should wrap no more than three wires at a time, and wrap in straight rows with no daisy chains.

If you’re planning to wrap two wires onto one pin, make sure the wires do not cross each other. Place them so the channels are parallel length-wise, leaving spaces between them, and make sure they go in the same direction as the solder joints. Also, ensure that the soldered connection is stable, because wire wrap can cause signal integrity issues.

When wiring circuit board, it is best to use a logical order. The pins should be wired in such a way that they stay snugly in place. This way, corrections can be made much easier.

Terminal block

There are several different ways to connect wires to circuit boards. The most basic method involves twisting the wires together. Another option is to use a connector or terminal block. The wires should be at least 97 percent flexible. You should avoid soldering them, since this will make them less flexible and may cause them to short out.

When wiring a PCB, it is essential to keep the end of the wire at least twice as wide as the existing trace. It is also important to keep the area straight. To do this, you can use a wire guide tool or polyamide tape to hold the wire in place. Once it is in place, you can attach it to the board using adhesive or epoxy.

The next step is to insert the wire end through the solder pad on the board. The wire tip should be slightly curved to prevent the wire from falling out during soldering. Be sure to keep the wire away from the other pads on the board, especially the ones that touch the board. Then, you can attach the soldering iron to the wire tip and wait a few seconds. When the soldering iron reaches the pad, you will see a cupola-shaped splash of the solder. The board should be stationary for at least a minute.