Jak vyrábět desky s plošnými spoji

To complete fabrication of PCB, it is important to communicate with the CM and OEM. The two groups must use the same design files to avoid errors in the final fabrication process. The materials used to manufacture printed circuit boards must also be cost-effective for the final purchaser. The OEM must agree on the type of materials to use for the PCB design, while the CM must make sure that the materials are within their budget.

Controlled depth drilling

Controlled depth drilling is used to connect copper layers on a PCB board. It can also be used to pre-drill a PCB sheet. It is important to use the right drill size for the particular material and thickness of the PCB board. If you are unsure of the proper depth to drill, a professional can help you.

Controlled depth drilling can help reduce the signal reflection caused by via stubs. It also reduces EMI/EMC radiation. The process is most effective for high-frequency PCBs. However, it requires a unique drilling technique to avoid damaging lateral traces.

Leptání

Etching PCB boards is a simple procedure that involves dipping a PCB into an etchant solution containing ferric chloride. This solution reacts with the copper on the board and removes the unwanted copper. You must remember not to pour the solution directly on water and to dry the PCB properly after the process.

During the etching process, you should have the necessary tools and materials ready. Once you have these materials, it is time to begin the process. The following steps will walk you through the process of etching a PCB board. The materials you will need are listed below. For each of the materials, you will need a certain amount of water.

First, you must prepare the PCB by applying a thin layer of tin or lead. This will protect the copper on the board from getting damaged. Then, you will need a chemical solution that will remove the tin without damaging the copper circuit tracks. After this, you will be able to pass it on to the next step. Next, you need to apply a solder resist material to the area where the copper is not soldered. This will prevent the solder from creating traces and shorting nearby components.

Laminating

Laminating PCB boards is the process of covering printed circuit boards with a protective film. A PCB laminate can protect your circuit board by reducing the amount of exposure to harmful elements, such as halogens. These elements are harmful to humans and the environment. While there is no specific requirement for PCB laminates, it is a good idea to consider it if there is a possibility that your product will be exposed to halogens.

A laminator has multiple plates that can be loaded in. During the lamination process, a PCB is placed between the plates and aligned with the pins. This process is called “lamination,” and it is done under high temperature and pressure. During the lamination process, a vacuum is used to prevent any voids from forming within the circuit board and prevent it from losing its structural integrity.